سوال یکی از دوستان چون متاسفانه نمیتونستم تو قسمت پیام خصوصی براشون اپلود کنم اینجا قرارش میدم
یه سوال درصد خلوص kcl خریداری شده 100 درصد می باشد تو فرمول نیازی نیست این عدد قرار بگیره ؟
سوال یکی از دوستان چون متاسفانه نمیتونستم تو قسمت پیام خصوصی براشون اپلود کنم اینجا قرارش میدم
با سلام
مقاله فارسی میخواستم در رابطه با موضوع :
شیرین سازی نفت داخل مخازن توسط میکروارگانیزم ها
و
کاربرد حلال های جدید ( از جمله مایعات یونی ) در شیرین سازی گاز
با تشکر
بد اخلاق!چیز دیگه ای نمی خوای ؟
این چه طرز درخواست؟ اولا دقیقا موضوعتو مشخص کن- دوما توی مقالات فرمول اثبات نمیکنن.ثالثا اینجا مقاله ترجمه شده فکر نمیکنم باشه همه لاتینه اگه فارسی میخوای میتونی به civilica.com یه سر بزنی .رابعا موفق باشی
دوست خوبم اگه می خواین بچه ها سریع تر بهتون پاسخ بدن باید سوالتون رو شفاف و همراه با جزئیات مطرح کنید. سوالات کلی که ایده ای توش نداشته باشه (مثل سوال شما) اگه حتی تو چند تاپیک مختلف مطرح بشه معمولا بی پاسخ می مونه.
یه سوال درصد خلوص kcl خریداری شده 100 درصد می باشد تو فرمول نیازی نیست این عدد قرار بگیره ؟
سلاام . من دنبال گزارش کار آموزی یه واحد یوتیلیتی میگردم توی قسمت پروژه و کاراموزیم گشتم ولی فایلش موجود نبود! کسی میتونه کمکم کنه؟ خیلی ضروریه
ممنون از لطفتون.من در واقع دو مقاله خوب از ترمو و حرارت میخو ام که فرمولایی که توش نوشته شده رو باز کرده باشه و اگه نیاز به رسم نمودار داشته باشه رو رسم کرده باشه راجب هر موضوعی هم باشه ایراد نداره
سلام
برا ارشد آزاد که میدونم مهم نیست لیسانس چی خونده باشی
میتونی هر چی میخوای امتحان بدی
برا دکترا هم همینطور هست ؟
این موضوع که خیلی جنراله و کلی مقاله و موضوع براش وجود داره، با یک سرچ ساده تو گوگل یا ساینس دایرکت کلی مقاله پیدا می کنید.
سلام
برا ارشد آزاد که میدونم مهم نیست لیسانس چی خونده باشی
میتونی هر چی میخوای امتحان بدی
برا دکترا هم همینطور هست ؟
سلام دوستان
چنتا سوال در مورد آزمون دکترا داشتم
اول اینکه به نظرتون اگه از الان بخوام برای دکترا بخونم میتونم تا موقع آزمون آماده باشم؟ یعنی دیر نشده؟ (با توجه به اینکه من دانشجوی ارشدم هنوز و مشغول انجام پایان نامم هستم)
سوال دومم اینکه از چه کتاب، جزوه یا نمونه سوالاتی استفاده کنم بهتره؟
ممنون میشم راهنماییم کنید....
سلام .امکانش هست این مقاله ها رو برام دانلود کنید. ممنون
http://www.civilica.com/Paper-SDTC02-SDTC02_040.html http://www.civilica.com/Paper-SDTC02-SDTC02_013.html http://www.civilica.com/Paper-SDTC02-SDTC02_044.html[/QUOTE مرسی پچه ها دانلود کردن.
دوستان يه سوال دارم.
يه مخزن 15000 ليتري اب داريم با ph تقريبا 8
چه مقدار اسيد سولفوريك با غلظت 95 درصد به اين مخزن اضافه كنيم تا ph مخزن به 5 برسه؟
نحوه محاسبه اون رو لطفا بيان كنيد.
همچنین اگه ph اسید سولفوریک حدود 0.5 باشه غلظت اون رو چطور میشه حساب کرد؟
کسی نمیتونه این سوال رو جواب بده؟
دوستان يه سوال دارم.
يه مخزن 15000 ليتري اب داريم با ph تقريبا 8
چه مقدار اسيد سولفوريك با غلظت 95 درصد به اين مخزن اضافه كنيم تا ph مخزن به 5 برسه؟
نحوه محاسبه اون رو لطفا بيان كنيد.
همچنین اگه ph اسید سولفوریک حدود 0.5 باشه غلظت اون رو چطور میشه حساب کرد؟
دوست عزیز سوالتون رو اگر در قسمت نرم افزارهای مهندسی شیمی بخش متلب مطرح میکردین دوستان بهتر پاسخگو بودن
اگه میخواین زودتر به جواب برسین لطفاً با دوستانی که از اعضای باشگاه هستن و کار با متلب رو بلدن تماس بگیرید
اگه بصورت تخصصی بخوام، موارد زیر هست که من نتونستم چیزی پیدا کنم،شاید هم بلد نبودم خوب search کنم :
effect of temperature in gas Lift
effect of pressure in gas Lift
effect of composition in gas Lift
اولا از لطفتون خیلی ممنونم.سلام
سرچ با ساینس دایرکت یا اسکوپوس رو بلدین ؟
Pumping characteristics of a large-scale gas-lift system
Abstract
In this study the hydrodynamics of a gas-lift system for CO[SUB]2[/SUB] sequestration at deep sea (so-called “GLAD System: Gas Lift Advanced Dissolution System”) are investigated. Experimental results are presented for both laboratory and pilot scale gas-lift pumps, ranging from 47 to 151 mm in diameter and 7.7 to 196.6 m in height. It was found that for each pump geometry a maximum liquid flowrate was achieved for the range of gas injection rates studied. Moreover, the liquid-phase hold-up was adequately modeled based on a gas-phase Froude number and applying 1-D Drift-Flux analysis. The axial pressure distribution for both scale systems exhibited similar properties when normalized with respect to overall pipe length and outlet absolute pressure. A simple hydrodynamic numerical model was found to adequately predict the induced liquid flowrate for a given gas injection rate. Closer agreement is expected when frictional losses for non-smooth pipe surface are taken into account as well as dissolution of gas from the rising bubbles. Further work
in this area is currently in progress.
Experimental investigation of three-phase flow in a vertical pipe: Local characteristics of the gas phase for gas-lift conditions
Abstract
Laboratory experiments have been performed on the flow of oil, water and air through a vertical pipe in order to study the gas-lift technique for oil–water flows. Special attention was paid to the phase inversion phenomenon, by which the continuous phase switches to the dispersed phase and vice versa. By using different types of gas injectors the influence of the bubble size of the injected air on the efficiency of the gas-lift technique (in particular at the point of phase inversion) was studied. Also the gas and liquid mixture velocities were varied. The air bubbles were detected by means of optical fibre probes. Local measurements of the time-averaged gas volume fraction, bubble size and bubble velocity were carried out, as well as pressure measurements.Phase inversion is associated with a sharp increase of the pressure gradient. With air injection the pressure gradient (for the oil–water–air flow) is always significantly smaller than for the case of oil–water flow, except at the point of phase inversion where the pressure drop can be even be higher than for oil–water flow. It was also found that air injection does not significantly change the critical concentration of oil and water where phase inversion occurs. An important phenomenon to explain these results is, that the presence of the dispersed (oil or water) phase has a significant influence on the bubble size. Also the influence of the gas flow rate on the distribution of the oil and water phases in a cross-section of the pipe plays a significant role.
Influence of gas injection on phase inversion in an oil–water flow through a vertical tube
Abstract
An experimental study has been made of the influence of gas injection on the phase inversion between oil and water flowing through a vertical tube. Particular attention was paid to the influence on the critical concentration of oil and water where phase inversion occurs and on the pressure drop increase over the tube during phase inversion. By using different types of gas injectors also the influence of the bubble size of the injected gas on the phase inversion was studied. It was found that gas injection does not significantly change the critical concentration, but the influence on the pressure drop is considerable. For mixture velocities larger than 1 m/s, the pressure drop over the tube increases with decreasing bubble size and at inversion can become even larger than the pressure drop during the flow of oil and water without gas injection.
امثال این مقالات زیاده، اینها به دردتون می خوره یا راه رو اشتباه رفتم ؟