sohrabi_never
عضو جدید
if you like to see the Tutorials of MPA&MPX&MPI
see this blog:
Moldflow Plastics Adviser's Tutorials
,Moldflow Plastics Adviser
,Moldflow Plastic Insight
,Moldflow Plastic Expert
,Material Reference
&full Glossary
,Moldflow Plastic Insight
,Moldflow Plastic Expert
,Moldflow Plastic Insight's Tutorials
,Moldflow Plastics Expert's Tutorials
,Moldflow Plastics Expert's Tutorials
,Material Reference
&full Glossary
Introduction:
"/TUTORIAL [Getting Started]
This tutorial introduces you to Moldflow Plastics
Advisers, and shows you how to assess the suitability
of your model for manufacture using plastic injection
molding techniques.
"/TUTORIAL [Reports]
You can use the Report Generator to create a report on
a set of results. The report can include text, still
graphics, and animations. The following tutorial shows
you to how to use the report wizard. There are eight
tasks to complete in this tutorial.
"/TUTORIAL [Single Cavity]
This tutorial shows you how to create a runner system
for a single cavity in a 3-plate mold.
MOSTAFA SOHRABI.