How Much Force Applied to Rig Tong To Get The Right Torque at The Connection

hmdjml

مدیر تالار مهندسی نفت
مدیر تالار
[h=1]How Much Force Applied to Rig Tong To Get The Right Torque at The Connection[/h]


One application of the rig tong is to use to make up connection. The question is asked about how to get the right torque value to the connection if you use the rig tong because you will not see the torque value on the gauge.​

This article will describe how to determine the correct force applied to get the correct torque value when you use the rig tong to make up the connection.​
This formula below is used to determine torque value.​
[h=1]Torque = Force x Length of the tong[/h]
Where;
Torque in ft-lb​
Force in lb​
Length of the tong in ft​
Force is perpendicular to the tong length. The illustration below demonstrates the direction of force.​
Example: Connection 4-1/2” IF – required make up torque = 30,700 ft-lb.​
Tong length is 4 ft​
How much pulling force do you require to achieve the required make up torque?
Torque = Force x Length of the tong​
Re arrange the equation:​
Force = Torque ÷ Length of the tong​
Force = 30,700 ÷ 4.0​
Force = 7,675 lb​
Ans: 7,675 lb pulling force is applied to 4-ft tong in order to get the torque at connection at 30,700 ft-lb.

Ref Book -> Applied Drilling Engineering Book
 
بالا